U.S. commercial & utility-scale solar foundationsBid packages: bids@sunpile.com
SUNPILE Request a Bid

Foundation systems

Helical piles & ground screws for difficult solar terrain

Torque-installed foundations for rock, caliche, glacial till, soft clay, frost heave and slopes.

Two different tools

Helical pilesGround screws
GeometrySteel shaft with one or more helix plates, or continuous flightTapered shaft with a forged or cast threaded tip
Best groundSoft clay, peat, wetlands, frost-heave zones; bears on deep strataCaliche, dense gravel, glacial till, rocky hillsides, steep slopes
How capacity developsBearing on the helix plates below weak layersThread engagement and shaft friction in dense ground
Typical depthDeeper; extended until torque target is metShallower, 5–8 ft typical
RockNot for competent rockPilot-drilled into soft rock where needed

Torque verifies capacity

Installation torque correlates with capacity: Qult = Kt × T, where Kt is an empirical factor that falls as shaft diameter rises (about 10 ft⁻¹ for small square-shaft helicals, lower for larger round shafts). Logging torque on every pile gives a capacity check across the site, not just at the test locations. Load tests on representative piles calibrate Kt for the site. See ASTM D3689/D3966 testing.

Why EPCs pay the premium

  • No refusal adder. Screws go through ground that would stop a driven pile, so there is no pre-drill, grout or rig standby.
  • No concrete and no cure. Racking can load immediately after install.
  • Slopes and grade. Screws handle undulating terrain with less grading.
  • Removable. Screws back out at decommissioning, which can lower the end-of-life bond and restoration cost.

Installed pricing

$120–$250per pile, utility volume
$180–$400+per pile, C&I footprints
$0.03–$0.07foundation share per Wdc at utility pile counts
20–40%unit premium over clear-site driven steel

The unit premium over driven steel is the reason screws lose on clean sites and win on rocky ones. The crossover is usually around 25–30% refusal. Test it with your numbers in the estimator.

IRA domestic content

Ground screws and helical shafts are structural steel foundation items under IRS Notices 2023-38, 2024-41 and 2025-08, so they need 100% U.S. melted and poured steel for the domestic content bonus. Confirm the mill origin of the shaft tube or bar, not just the final fabricator. MTR checklist →

Utility solar plant spread across rolling terrain
Rolling or rocky terrain is where torque-installed foundations earn their premium.

Send the pile schedule. Get a foundation bid.

MWdc, racking, geotech status and mobilization window are enough to start. Steel supply, driving crews, ground screws, pre-drilling and load testing priced as one package or line by line.

Request a Bid